Fórum - Téma


Jak na to


Fórum Technický koutek Jak na to



1 ......... 4  5  6  7  8

Zamčeno: 2016-12-06 07:28:56, Matrix
Matrix  
Martin
2016-09-20 08:40:34

Repair cracking and torn automotive leather. https://scratchwizard.net/

TRANSCRIPT:

Before then after photo of repair.

In this video you will learn to fix small tears and cracks in automotive leather with Scratchwizard’s leather repair kit.

On table.

You will need our leather repair kit, which includes leather filler, a palate knife, patching material, color-matched leather dye, leather cleaner, a scuff pad and 600 grit sandpaper. Additionally, you’ll need soapy water, a lint free cloth, tweezers, and a heat gun.

Chair on table. Simple green and towels.

It’s a good idea to give the entire seat a good general cleaning. This will reveal the true color of the leather and allow the repair materials to form a stronger bond. Very fine steel wool can help separate years of dirt and oils from the leather.

Leather cleaner and scuff pad.

Now use the supplied leather cleaner and scuff pad to clean and scuff the areas you’ll be repairing.

[title: RIP REPAIR]

Seat with the big rip.

Don’t attempt to repair large rips like these. Have this repaired by an upholstery shop.

Seat with small rip (zoom in)

But you can repair a rip of this size. Here’s how.

Scissors and backing pad.

Cut out a piece of the supplied patch material. It should be roughly the shape of the tear, but about a ¼” larger around the edges.

Palette knife, filler, and tweezers

Apply a fine layer of leather filler to the patch. Now insert the patch into the hole. A pair of tweezers can be helpful. Wait an hour for the patch to bond to the underside of the leather.

[TITLE: CRACK REPAIR]

Palettte knife, filler, and heat gun

Apply fine layers of leather filler to the cracks, including the the tear you just repaired. You can use a heat gun on low setting to accelerate the drying of the filler. Check that the filler is try with your finger before proceeding to add another layer of filler.

Once you have filled above all cracks, and your filler is dry. Sand the filler with 600 grit sandpaper. Sand in one direction, like this. You may have to swap in fresh sandpaper when it gets filled with leather filler.

Spray can and heat gun

Apply the color-matched dye in light, thin coats. A heat gun will on a low setting will help to accelerate drying times. Once the filler is covered with dye, apply at least 2-3 more coats of dye to ensure durability.

When finished, avoid sitting in the chair for at least one hour.

Matrix  
Martin
2016-09-20 08:47:01

DIY Rust Repair Cheap And Easy!

In this video I filmed from start to finish as I repaired the door sill on my 2009 Volkswagen Jetta Wolfsburg. This is by no means the "right way" to do the job. The only way to completely remove rust is to cut it out and weld in a replacement piece of steel. This video is for those of you who are sick of looking at a rust spot on your car and don't want to spend the money at a professional auto body repair shop. In this video I explain the step by step DIY process of how to repair rust and paint your car, motorcycle, tractor, etc.

Matrix  
Martin
2016-09-30 17:19:02

Disconnecting the Fuel Rails and Removing the Fuel Injectors from an Aston Martin DB9

How to disconnect the fuel rails and remove the fuel injectors from a 2005 Aston Martin DB9 Coupe. More details are available on blog https://aston1936.com/201...from-an-aston-martin-db9/ and https://aston1936.com/201...s-in-an-aston-martin-db9/

Matrix  
Martin
2016-09-30 17:21:12

Preparing the Intake Manifolds for Removal from an Aston Martin DB9

How to prepare the Intake Manifolds for removal from a 2005 Aston Martin DB9 Coupe by disconnecting the ancillaries. Learn more on blog https://aston1936.com/201...from-an-aston-martin-db9/

Matrix  
Martin
2016-09-30 17:24:26

V8 Vantage Brake Pad Swap

How to replace the front brake pads on an Aston Martin V8 Vantage

Matrix  
Martin
2016-09-30 17:29:09

Voice settings on upgraded sat nav for the Aston Martin V8 Vantage

Matrix  
Martin
2016-10-03 12:17:52

Leather Recolouring Aston-Martin

The leather on this DB7 was looking a little tired, so we re-coloured the leather.

Matrix  
Martin
2016-10-05 07:55:06

Removing the Intake Manifolds from an Aston Martin DB9

Final steps in the process of removing the Intake Manifolds from a 2005 Aston Martin DB9 Coupe. You can learn more of the preliminary steps and complete details about this step in blog at https://aston1936.com/201...from-an-aston-martin-db9/

Matrix  
Martin
2016-10-09 11:28:48

Removing the Spark Plug Covers from an Aston Martin DB9

How to remove the Spark Plug Covers from a 2005 Aston Martin DB9 Coupe. More details are available on blog at https://aston1936.com/201...from-an-aston-martin-db9/

Matrix  
Martin
2016-10-12 07:15:04

Installing the Updated Idler Pulley and FEAD Belt on an Aston Martin V8 Vantage

4.3L V8 Vantages often develop a chirp-chirp-chirp sound when started while the engine is cold. The problem was fixed with the 4.7L engines, and the revised parts on those cars are the retrofitted solution for the earlier ones. This video shows what's involved with installing the updated idler assembly (pulley) and FEAD belt (serpentine/accessory belt) to fix the cold-start chirping problem on the 4.3L V8 Vantage.

For a full write-up and DIY guide, visit: http://www.redpants.lol/u...-and-pulley-installation/

Matrix  
Martin
2016-10-13 05:25:14

Replacing the Cabin Air Filters in an Aston Martin V8 Vantage

Cabin air filters help keep the cabin of your car fresh and clean by filtering out the dust, smog, and debris (including pine needles, leaves, and bugs!) as the climate control system pulls in air from outside the car. They need to be replaced every 1-2 years, depending on where you live and how often you want to change them. This is a really easy job that only requires a Philips-head screwdriver to do, you just need to know a couple important things before you begin!

Matrix  
Martin
2016-10-13 05:26:37

How to Modify the Grille of an Aston Martin V8 Vantage

This is a quick video showing how to remove the slats from the grille of an Aston Martin V8 Vantage. It's a quick and easy way to modify (or repair, if needed) the grille of the car.

Matrix  
Martin
2016-10-16 14:05:07

Removing the Coil Packs from an Aston Martin DB9

How to remove the Coil Packs from a 2005 Aston Martin DB9 Coupe. More details are available on blog at https://aston1936.com/201...from-an-aston-martin-db9/

Matrix  
Martin
2016-10-17 06:23:18

Removing the Spark Plugs from an Aston Martin DB9

How to remove the Spark Plugs from a 2005 Aston Martin DB9 Coupe. More information is available on blog https://aston1936.com/201...from-an-aston-martin-db9/

Matrix  
Martin
2016-10-22 07:04:26

Installing a Shorty Antenna on an '06-07 Aston Martin V8 Vantage

This is the quickest and easiest job ever. Twist the old antenna off, twist the new antenna on! For more information, check out http://www.redpants.lol/shorty-antenna/

Matrix  
Martin
2016-10-25 06:05:42

Preparing and Installing the Spark Plugs into an Aston Martin DB9

How to prepare and install a set of Spark Plugs into a 2005 Aston Martin DB9 Coupe. More information is available about the process on blog https://aston1936.com/201...into-an-aston-martin-db9/

Matrix  
Martin
2016-10-30 13:49:31

Preparing and Installing the Coil Packs into an Aston Martin DB9

How to prepare and install the Coil Packs into a 2005 Aston Martin DB9 Coupe. More information is available about the process on blog https://aston1936.com/201...into-an-aston-martin-db9/

Matrix  
Martin
2016-11-07 09:09:27

Installing the Spark Plug Covers on an Aston Martin DB9

Details on how to install the Spark Plug Covers on a 2005 Aston Martin DB9 Coupe. More details are available on blog https://aston1936.com/201...s-on-an-aston-martin-db9/

Matrix  
Martin
2016-11-23 06:09:31

Removing the Armrest and Lower Console Panel from an '06-07 Aston Martin V8 Vantage

This is a quick video showing how to remove the armrest and lower console panel from a MY06-07 Aston Martin V8 Vantage. The armrest was redesigned for MY08 so that year and newer have a couple extra screws in the armrest.

For a full DIY guide, go to http://www.redpants.lol/a...nd-lower-console-removal/

Matrix  
Martin
2016-11-23 06:11:22

Aston Martin DB9 Console and Nav Bezel Removal

DISCLAIMER: As always, follow all safety protocols. Don't undertake this task if you aren't comfortable with it and fully understand it. You are ultimately responsible for anything you do. Neither Redpants, LLC or myself is responsible or liable for anything that may occur.

For a full DIY guide, visit http://www.redpants.lol/l...le-and-nav-bezel-removal/



1 ......... 4  5  6  7  8